![]() Required software DASYLab (purchased version or evaluation license) MCC InstaCal driver and utility software (version 6.23 or later) You can download the DASYLab evaluation, InstaCal, and any software updates and service packs from the Software/Drivers Downloads page at System requirements DASYLab requires the following minimum hardware and operating system requirements. Please read this document completely before you install any software or hardware. Instructions on installing and using InstaCal are included below. ![]() ![]() You must first configure your MCC USB device with InstaCal the installation, calibration, and test utility for MCC hardware before you can use it with DASYLab. DASYLab is an icon-based data acquisition, graphics, control, and analysis software package. This Quick Start document contains the latest information on downloading, installing, and using DASYLab version and the MCC-DRV driver with your USB device. 1 Quick Start Using DASYLab with your Measurement Computing USB device Thank you for purchasing a USB data acquisition device from Measurement Computing Corporation (MCC).
0 Comments
Leave a Reply. |